English
Chinese
CC-LINK
Home > Products > Horizontal I/O> CC-LINK > UH-CL-D32C000
Product search
Product Catalog
| Numeric input parameter | |||||
| Type | UH-CL-D32C000 | ||||
| Number of channels | 32 | ||||
| Signal type | NPN & PNP | ||||
| "ON" signal voltage (PNP) | 15V - 30V | ||||
| "OFF" signal voltage (PNP) | -3V - 3V | ||||
| "ON" signal voltage (NPN) | -3V - 3V | ||||
| "OFF" signal voltage (NPN) | 15V - 30V | ||||
| Connection type | 1 - Wire system | ||||
| Reverse circuit protection | Yes | ||||
| Isolation mode | Optical isolation from the field layer | ||||
| Error diagnosis | Yes | ||||
| Typical input current | 3mA | ||||
| The maximum crimp area of the wire | 1.5mm² | ||||
| Maximum crimp area of conductor (AWG) | AWG16 | ||||
| The minimum crimp area of the wire | 0.34mm² | ||||
| Minimum crimp area of conductor (AWG) | AWG22 | ||||
| Strip length | 8-10mm | ||||
| Communication parameter | |||||
| Communication protocol | CC-LINK | ||||
| Transmission rate | Five speed can be set： 10 Mbps / 5 Mbps / 2.5 Mbps / 625 kbps / 156 kbps | ||||
| Communication distance | 10 Mbps | 5 Mbps | 2.5 Mbps | 625 kbps | 156 kbps |
| ≤100 m | ≤160 m | ≤400 m | ≤900 m | ≤1200 m | |
| Station type | Remote I/O station | ||||
| Occupied work station | 1 station | ||||
| Topological structure | Bus topology | ||||
| Isolation mode | Electrical isolation from field floor | ||||
| Transmission medium | CC-Link Special Cable (three-core shielded stranded cable) | ||||
| Power supply parameter | |||||
| Connection mode | PUSH-IN terminal | ||||
| Operating voltage | 24V DC +20%/-15% | ||||
| System feed current | <150mA | ||||
| The maximum crimp area of the wire | 1.5mm² | ||||
| Maximum crimp area of conductor (AWG) | AWG16 | ||||
| The minimum crimp area of the wire | 0.34mm² | ||||
| Minimum crimp area of conductor (AWG) | AWG22 | ||||
| Strip length | 8-10mm | ||||
| Basic parameter | |||||
| Class of protection | IP20 | ||||
| Overall dimension(H x W x D) | 43.7 mm X 100 mm X 100 mm | ||||
| Operating temperature | -10 ~ 55°C | ||||
| Storage temperature | -20 ~ 85°C | ||||
| Relative humidity | 5 ~ 95% RH (non-condensing) | ||||
| Authentication | CE | ||||
| Altitude | Below 2000 meters( 80kPa) | ||||
| Pollution level | Level 2 | ||||
| Immunity to interference | Power cord 2kV（IEC 61000-4-4） | ||||
| Overvoltage class | II | ||||
| EMC anti-interference level | Zone B，IEC61131-2 | ||||
| Vibration resistance | IEC 60068-2-6 | ||||
| 5Hz ~ 8.4Hz, amplitude 3.5mm, 8.4Hz ~ 150Hz, acceleration 9.8m /s², X, Y, Z | |||||
| 100 minutes in each direction (10 times, 10 minutes each, 100 minutes in total) | |||||
| Impact resistance | IEC 60068-2-27, 9.8m/s², 11ms, X/Y/Z, 3 times each in 3 axes and 6 directions | ||||
| LED status | |||||
| PWR | On: The power supply to the module is normal | ||||
| Off: The power supply to the module is abnormal | |||||
| RUN | On: The system is running properly | ||||
| Off: The system is not running properly | |||||
| PORT1 | Blinking: Data is available on the network | ||||
| PORT2 | Blinking: Data is available on the network | ||||
| Channel light | On: The signal of the corresponding channel is valid | ||||
| Off: The signal of the corresponding channel is invalid | |||||
| Ps | On: The power supply to the system is normal | ||||
| Off: The system power supply is abnormal | |||||
| Pf | On: The onsite power supply is normal | ||||
| Off: The onsite power supply is abnormal | |||||
